Dew Heaters for Night Sky Photography

03
Jun

Dew Heaters for Night Sky Photography

This article describes a cheap, lightweight and effective solution to dew for night sky photography.

One of the more annoying aspects of Night Sky Photography is dealing with dew. Particularly in moist climates on a cold night, moisture in the air can condense onto the cold front surface of your lens quite quickly. This can bring a night of winter photography to a rapid close and can rule out long star trail exposures or timelapse sequences.

Astronomers doing serious astrophotography routinely use Dew Heaters with four channel controllers to keep their telescopes free from dew. However, they normally are working with mains power or at least large batteries available, whereas for night sky photography we are often seeking out remote and hard to access locations. The commercial controllers for these dew heaters have three issues as far as night sky photography is concerned:

  1. Expensive: $100+ just for the dew heater controller. This might be ok when you need multiple outputs to protect a telescope and guidescope, and possibly finderscope/eyepiece/camera lens as well, but that's an expensive solution to keeping just one camera lens free of dew. These controllers also make sense when you need fine control over the amount of heat applied to avoid telescope tube heat currents and the thermal distortion of delicate telescope lenses and mirrors. However, with wide angle camera lenses these issues are not generally relevant.
  2. Complicated: It's another black box and an extra length of cables and connectors to carry and hook up.
  3. Require heavy batteries: These controllers are designed to run off lead-acid batteries providing greater than 12 volts (and are often powered by DC power supplies connected to mains power). All the newer controllers will cut-out if the voltage drops below 12 volts, to protect the lead-acid battery from being over-discharged. This is great for protecting your battery, but a lead-acid battery that can provide several amp-hours of heating in cold conditions and still stay above the cut-off voltage ends up being quite heavy and inconvenient to carry up a mountain for example.

Lithium-ion batteries offer a great lightweight alternative to lead-acid batteries, but because their supply voltage quickly drops below 12 volts, they cannot be used with the existing commercial dew heater controllers. With the high resistance of the small dew heaters for wide-angle lenses, they can be run directly from 12 volt supply without any controller, but there is no easy way to plug the standard RCA connector on a dew heater to a DC power supply (RCA was a dumb connector to choose as the standard for dew heaters).

A Lightweight, Cheap and Simple Dew Heater for Night Sky Photography

To solve all the above, there's a very simple solution. There are just three parts to what I now use as a lightweight, cheap and very simple dew heater for my own night sky photography:

1: 12 volt Lithium-ion battery

I have been buying these via the DHGate website: http://www.dhgate.com/product/portable-super-capacity-rechargeable-lithium/144319862.html. You may also find them on ebay with a search for "12v 6800mah Lithium-ion battery" but they are getting harder to find at affordable prices. There are some that are nicely packaged in a black housing while others are blue and look closer to the raw product from the factory. You'll generally need to buy a US power plug adapter for your region as well, as they usually only come with a US charger.

2: Dew heater strap

I use the Dew-Not dew heater for 2 inch eyepieces (DN003). These are considerably cheaper than the Kendrick Firefly alternatives. While the Kendrick heaters are high quality, the two available options end up being just a little too large or small - more on that below.

Dew-Not 2 inch heater - $22 plus shipping or Kendrick 2 inch heater - $43 plus shipping

3: Adaptor Cable

You need an adapter cable with RCA female at one end and male DC 2.5mm plug at the other (to connect male RCA of dew heater at one end into female DC socket on battery at the other end).

Dew Heater Adapter Cable

Buy one on Amazon

Instructions to make your own are below, but if DIY cables is not your cup of tea, I've now got them available to buy on Amazon. Australian residents can buy via AstroShop for quicker delivery and to support a local retailer.

Make your own adapter cable

You can buy components for this on ebay searching for: "2 RCA female" ebay example "2.5mm 5.5mm DC male" ebay example Then you have to cut and solder the two wires from one female RCA to one DC connector together. Of course, you could just cut off the RCA end of the dew-heater and solder the DC connector on, but then you lose the ability to use it with the commercial controllers, should you ever want to. If you want to make the dew heater itself, there are instructions here. As referenced on that page, you can also buy very cheap 12 volt dimmers on ebay which reduce the power demand from the heater when you don't need much power to prevent dew.

Power Use and Specifications

The Lithium-ion batteries run at around 11.5 volts (anything from 12.6 fully charged down to less than 10 at full discharge). The Dew-Not 2" heater has 38 ohms resistance. This draws current of 0.3A and power output of 3.4W which is plenty for just a camera lens. On paper you should get 22 hours run-time from the 6800mah battery but I would not assume anything like that. I do comfortably get 8 hours run-time out of them (perhaps less in extreme arctic cold conditions though). If they are flat, the batteries can take a *long* time to recharge so put them on to recharge early in the day if you want to reuse them again the next night. The 2" Dew-Not heater (~20cm) plus elastic and velcro is long enough to go round all my lenses, although there can be a bit of a gap in the heater material with just the elastic reaching round the last bit of the lens, but in practice this is fine. The 2" Kendrick heater (~15cm) is a bit shorter leaving a larger gap and in some cases even the velcro does not reach round to attach at all around very big lenses. But the higher resistance of 49 ohms draws less power (0.23A, 2.7W) meaning longer battery life. In many situations this may actually be preferable. The 3" Kendrick heater (~25cm) has a lower resistance of 29 ohms and probably draws more than ideal (0.4A, 4.5W) from the Lithium-ion battery.

When it's all connected together, it looks like this. The dew heater and battery can now all fit in one pocket and it's easy to carry round and hook up.

Other Methods to Limit Dew

The aim is to limit cooling by radiation of heat from the lens to the sky and enhance (where possible) the warming of the lens through conduction/convection with the air around it or by exposure to infrared radiation from trees/rocks close the camera. Some of these ideas are occasionally useful in practice. Often though you will be fighting a losing battle and some form of external heat (dew heaters) is essential.

  • Keep the lens cap on and/or point the camera down at the ground when not in use.
  • Leave the camera in an area exposed to the wind. Heat that the lens loses through radiation will be regained by conduction/convection from the air around it.
  • Use the camera near rocks, a wall or even trees that will radiate their own heat back towards the camera.

It is also possible to use some types of chemical heat packs as a crude dew heater. The cheap single-use dry powder type packs available widely now are attractive but I have not had great success with them. They seem to need some continued agitation (as they might get in your pocket for instance) to keep some air moving through the powder and the reaction going. Strapped firmly to the outside of a lens I find they don't stay warm for as long as they should. If you want to read further, here is an interesting article on what causes dew on objects outside at night: Dew, Frost, Condensation and Radiation. It is written primarily from an interest in camping, but is still a great explanation and exploration of the issue of dew.

3 Comments

I've been toying with the idea of some night photography with my cheap little point and shoot digital camera. Living in south Alabama we tend to be able to carve chunks of humidity up, put them in a flat-rate postal box, and mail them to friends who have moved away and miss the humidity! ;)

Thus, I've be toying with ideas to keep dew off of the lense. I could not find the 2" band but that is irrelevant for my case as it would be too large. I've thought of a couple of things to try... One is a small computer fan to blow a gentle breeze across the front of the lense...cigarette lighter plug-in or small SLA battery would work well. The other option I've thought about is one of the pipe wrap tapes used to keep exposed water pipes from freezing...would require a larger battery and inverter, though. I might even try an array of small resistors. The fan should work with a fixed lense while either option would work with a camera that has a retractable lense.

Again, these ideas are for point and shoot cameras. For a DSLR with large lenses your option (where is that 2" wrap located?) is nice and should be somewhat inexpensive.

Take care,
Ed

Can this double over as a "Peter Heater?" :-)

I used the link to purchase one of these 12 volt, 6800 mAh batteries BUT the battery supplied was not the one described on the eBay web site.
They sent me a 4000 mAh battery instead of a 6800 mAh battery. The battery does not power the Dew Not heater band at all.
The suppier does not think that it is an issue to supply a different product to the one that he advertises.
DO NOT USE THIS VENDOR.
http://www.ebay.com.au/itm/2014-Best-12V-6800mAh-Li-ion-Rechargeable-Bat...